Protocols

Communication with devices

Here is a commented log when formatting a SSSD floppy disk with the TI disk controller. Actually, this dump was achieved using MESS and putting in some printf lines.

XModem protocol

The XModem protocol transmits data in a sequence of blocks. Each block contains a part of the file to be transmitted.

Block

Block

Block

...

Block

The last block may require padding if the number of remaining bytes does not suffice to fill the block.

Each block contains a sequence number. When a block with the same number as the previous one is received, the receiver ignores the block.

Sender sending		Block		Block		...		Block		EOT
Receiver sending	NAK		ACK		ACK		...		ACK		ACK

The receiver has a timeout of 10 seconds, after which it transmits a NAK. The message sequence starts with the receiver sending the first timeout NAK to the sender, which may be sent immediately. All errors are retried for at most 10 times.

A NAK must be sent by the receiver if the block data are invalid. If the block number is not the expected next one or a repetition of the recent one, the sequence is out of sync, and the receiver shall send a CAN.

Standard XModem

Each block is defined in this way (numbers tell the number of bytes for each field):

1	1	1	128	1
SOH	Number	/Number	Data bytes	Checksum

The number is a sequence number which increases by one for each successive block. The first block starts at 1. The /Number field is the one's complement of the Number field and calculates as 255-Number. When the number reaches 256 it is reset to 0.

The checksum field contains the least significant byte of the sum of the data bytes of this block.

XModem-1K

XModem-1K is a variation of XModem with 1K (1024) bytes for each data block.

1	1	1	1024	1
STX	Number	/Number	Data bytes	Checksum

The sender may switch between 128-byte and 1024-byte blocks after receiving an ACK from the receiver.

XModem/CRC

In this variant, a more powerful checksum algorithm is used, the CRC16 algorithm. In order to negotiate this variant for both sender and receiver, the receiver sends a "C" as the first message instead of the NAK.

Sender sending		Block		Block		...		Block		EOT
Receiver sending	"C"		ACK		ACK		...		ACK		ACK

The blocks have this layout:

1	1	1	128	2
SOH	Number	/Number	Data bytes	CRC16